fit for Head rotor lsuzu C240,for Head rotor lsuzu 6SD1

fit for Head rotor lsuzu C240,for Head rotor lsuzu 6SD1

WH/AT/SA/PP +86 133/86/90/11/93

shary /at /china-lutong/ dot .net Mai

#fit for head rotor isuzu 4BD1#

#fit for head rotor isuzu 4hk1#

#fit for Head rotor lsuzu 10PC1#

#fit for Head rotor lsuzu 12PD1#

#fit for Head rotor lsuzu 3LB1#

#fit for Head rotor lsuzu 4BA1#



# how to install head rotor ? #

Positioning Heads On A Slope:

Special considerations should be made if the placement of a head is on a sloped area. Make sure to tilt the head perpendicular to the slope, unless the slope is greater than a 3:1 ratio (rise:run). Gravity causes the water being sprayed on a slope to be distributed unevenly. Pulling the throw a further distance downhill and throwing less of a distance uphill.

Due to:

Make Sure You Angle The Position Of Your Heads So That They Are Set Perpendicular To The Slope.

Do Not:

If You Don't Angle Your Heads Perpendicular You Will Erode Areas On The Slope

The spray will throw water a longer distance when it sprays down from a sloped area.

The spray will throw water a shorter distance when it sprays up on a sloped area.

Note:

Pipe laid out downhill is not a good idea. Water is constantly moving downhill. The water pressure is going to be greater at the bottom and the pressure will be less at the top. It is better to place the pipes perpendicular to the slope direction itself. Read here to learn more about how to measure slope.